, , , , , , ,

Hakko WICK No.3 2.0mm x 30m Desolder Braid

SKU: H87-3-30

Hakko
Availability:

In stock


Hakko WICK No.3 2.0mm x 30m Desolder Braid
Economical and easy-to-use Desolder braid
Handy for the removal of solder after dismounting surface-mounted components including BGAs

39.29 Ex VAT

In stock

Please note: Prices displayed are Exc. VAT and we are only able to accept orders in the Republic of Ireland from customers with a valid EU VAT Number. For customers without this number, please contact our Head Office on the Freephone Number shown above. Thank you

Faster thermal transmission for superior performance at lower temperature and with lower wattage soldering irons.

Three different
Regular type:Rosin flux treated copper braid
Unflux type:Untreated copper braid
No clean type:Low residue flux treated copper braid
Using ESD SAFE package

Removal for thru-hole…

H K Wentworth - HAKKO UK and Ireland distributor

Removal for bridging…

H K Wentworth - HAKKO UK and Ireland distributor

Usage/Applications

Desoldering wire is used to remove solder from an elemental device or from patterns on a printed circuit board (PCB) from which surface-mounted devices such as BGA (ball grid array) have been removed.

Trick to remove solder well with the desoldering wire

Wrong use of the desoldering wire may tear patterns from a PCB or damage discrete components. In order to prevent these problems, make sure to take the preventive measure below:

  1. Apply a bit of solder to the tip of solder iron.
  2. Apply a bit of solder to the tip of the desoldering wire. Cut the soldered tip of the wire at an angle of 45 degrees. Solder should remain attached.

Preliminary soldering improves heat conductance.

H K Wentworth - HAKKO UK and Ireland distributor

Put the desoldering wire onto the soldering part.

Press the desoldering wire with the soldering iron on the wire

After melted with the heat of the soldering tip, the solder is sucked up into the desoldering wire

Be careful not to press the soldering tip down for too long. Otherwise, the pattern will come off.

Remove the desoldering wire and soldering iron at the same time.

You may also like…